MILKY WAY 1U
16 Algorithm Stereo FX Processor with meta cv FX scan, pan and crossfade
Simple and effective stereo FX processor with advanced effects
16 types of effects are available: HALL REVERB, SHIMMER REVERB, ROOM REVERB, PLATE REVERB, SPRING REVERB, PING-PONG DELAY, TAPE ECHO DELAY, CHORUS, GATED REVERB, SPRING REVERB 2, REVERSED REVERB, FLANGER, RING MOD, OVERDRIVE, COMPRESSOR, FREEZER.
Meta cv effects scanning
Volume control knob with with VCA.
Input crossfader + panner
stereo out pins for daisy chaining with other 1U modules and compatible with Intellijel Mixup / Audio Jacks V2 Boards
also available in 3U / 6HP version
Power consumption:
120 mA +12V
15 mA -12V
0 mA 5V
Dimensions:
22 HP
42 mm deep (fits all Intellijel Palette cases etc.)
Modulargrid: BLACK / SILVER
Manual: 3U & 1U NEW MANUAL / OLD MANUAL
Firmware update: latest release V4.1 ‘Total Nightmare’ 25-MAY-2021
Want to pimp up your module’s look? Check its faceplate replacement & knobs
FAQ:
Audio works only from one output / my stereo field is somehow twisted/unbalanced. You may have altered the spatial settings (pan / span). Please refer to the manual or simply press ‘tap’ and ‘type’ buttons for longer than 5 seconds to reset the module.
My signal is distorted. Please check the Saturation section on page 1 of the manual. If this doesn’t help check the trimmer settings on the backside of the module.
Is there any wining noise in the module? No. There was only a small batch of 3U modules in 2018 year with the noise which later was fully eliminated. If you experience any noise with your Milky Way - contact us and we will help.
Rainbow cable pinout. Side red/brown pair of pins always correspond to -12V similar as with typical gray ribbon cable.
